#Fitpro watch bands free

The spring bar ends will then need to be placed into the small holes in the lugs to be completely installed. This step requires the spring bar to be compressed again in order to fit back between the lugs. Since the spring bars expand when removed, they are wider than the width between the inside of the lugs. Installing the replacement strap involves putting the spring bars into the replacement strap pieces and reinstall the spring bars between the lugs. Pull the spring bar out through the hole in the end of the strap piece (fig.

#Fitpro watch bands free

The strap piece will now be free from the watch case (fig 9). Gently pry one end of the spring bar out of its lug hole and move it out from between the lugs. Make sure that the fork end has purchase on the flanges of the spring bar end.

Holding the spring bar tool with your dominant hand like a pencil, position the fork end of the spring bar tool between one side of one of the strap pieces and the lug.

With the strap unbuckled and the pieces lying to the left and right of the watch case, firmly grip the watch case with your non-dominant hand (fig.

Place a barrier, such as a piece of paper folded to stand upright, another wide and flat desktop object, or perhaps one of your fingers behind the watch to prevent spring bars from flying off the work surface. Additionally, because of their small size, they are easy to lose. 7).Ĭaution: Spring bars are spring loaded and may fly off the watch. A spring bar tool is a long, thin tool with a forked end which, by engaging and applying pressure to the flanges of the spring bar, compresses the spring bar so that it can be removed and installed(fig. The spring bar ends fit into small holes inside a pair of lugs on the watch case. A spring bar is a spring-loaded and telescoping metal rod with double-flanges on each end (fig. Removing the strap involves removing the spring bars, which releases the strap pieces from the watch case.

Unclasp the watch strap from your wrist and place the watch face-down with the strap pieces lying to the sides of the watch case on a clean microfiber cloth or other soft pad (fig.

Make sure the cloth or soft pad is clean. The two strap pieces are held onto the watch case by two spring bars.Ĭaution: Dust or dirt particles on the cloth or soft pad will cause scratches to appear on the watch. Two pairs of lugs extend out from the case of the watch at 12 o’clock (top) and 6 o’clock (bottom) and have small holes on the inside to hold the spring bars (fig. Doing so allows easier access to the strap and spring bars and prevents the watch lens from being scratched. The watch is usually placed face down with the strap unbuckled on a soft pad with the lugs pointing out to the sides. The strap consists of two pieces: a short piece which is attached to the buckle and a long piece which is punched with holes for the buckle. Setting up the work space involves finding a sturdy level surface to ensure that the work space is stable, laying out a soft pad so that the watch is not damaged, and orienting the watch for easy access to the strap and spring bars.

Barrier such as a piece of paper or other wide, flat bottomed desktop object (optional, but recommended).

This is advantageous if your current strap is worn out or broken, if you want to change the look of your watch, or if you need to switch your current strap for one which is more appropriate for a certain occasion.ĮQUIPMENT In order to follow these instructions adequately, the following equipment is necessary(fig.

3).Ĭhanging a watch strap is a process that involves removing the old strap from the watch case and replacing it with a replacement strap.

These instructions do not cover every type of watch and strap combination, but covers only watches without drilled lug holes and with two-piece watch straps made of a flexible material, such as leather, fabric, or rubber (fig. The following instructions for removing and replacing a watch strap are geared toward the typical watch wearer with little-to-no experience changing straps.